Omega Series Controls HUNT Simplicity Architectural Full Range Fluorescent Dimmers for use with Electromagnetic Fluorescent Lighting 120V and 277V

Transcription

1 aáããáåö= Omega Series ontrols UN Simplicity rchitectural Full Range Fluorescent Dimmers for use with lectromagnetic Fluorescent ighting 120V and 277V unt ontrol Systems nc. Fort ollins O el: (970) Fax: (970) huntdimming.com 120V 277V 120V 277V SF-5 SF-527 SF-15 SF-1527 SF-10 SF-1027 Product Description:. ommercial-grade wall controls for 12 fluorescent lamps (compatible ballast requiredsee below). vory and white standard colors; custom colors available. No exposed heat sink. imited one-year warranty. Features: asy-to-operate, smooth-sliding linear control. Solid-state circuitry. RF filter. U isted. Fits in a standard 2" deep single-gang back box. Maximum number of lamps controlled by one dimmer: SF-5, SF-527: 12 lamps SF-10: 18 lamps SF-1027: 20 lamps SF-15: 28 lamps SF-1527: 30 lamps Dimming. t s all we do. Since ompatible allasts 120V G-Valmont 8G-1718 dvance Dim 240--P (2 lamp) G-Valmont 8G-5001 Universal 550- G-Valmont 8G-5007 (2 lamp) Universal P dvance Dim 140- Universal 502- (2 lamp) dvance Dim 140--P Universal 502--F-P (2 lamp) dvance Dim 240- (2 lamp) dvance Dim 240--P (2 lamp) 277V Universal P Universal 678- (2 lamp) Dimensions: SF-5, SF-10, SF-527, SF-1027 faceplate dimensions: 3" x 4 ½" SF-15, SF-1527 faceplate dimensions: 4 ¾" x 4 ½" ackbox dimensions on all models: 1 5/8" x 2 5/8" x 1 3/8" 50

2 nstallation and iring nstructions for UN Simplicity rchitectural lectromagnetic Fluorescent ontrols Single Pole and hree ay 120V, 60z hese dimmers are designed for electro-magnetic fluorescent, permanently installed fixtures using an approved ballast (see below) and rapid start 40 watt lamps. Models: -ine Series: F-5, F-5-3, F-10, F-15 ccent Series: SF-5, SF-5-3, SF-10, SF-15 Omega Series: SF-5, SF-10, SF-15 oad: ( minimum load of two (2) lamps is required) F-5, F-5-3, SF-5, SF-5-3, SF-5; F-10, SF-10, SF-10; F-15, SF-15, SF-15; 12 lamps 18 lamps 28 lamps aution: o reduce the risk of overheating and possible damage to other equipment, do not install to control a receptacle, a motor-operated appliance, or a transformer-supplied appliance. vertissement: Pour réduire le risque de surchauffes et les dommages possibles à l'autre équipement, ne pas installer pour contrôler une prise, un appareil moteur-fonctionné, ou un transformateur d'alimentation magnétique appareil fourni. Read arefully efore nstalling Dimmers: o avoid fire, personal injury, and/or damage to dimmer, turn power OFF at circuit breaker and test that power is OFF before wiring. Notes: 1.) Fins must be mounted in vertical position and must not be recessed into the wall. hen stacking dimmers or mounting one above the other, allow a minimum of three inches of clear wall space between the upper and lower finned plates. 2.) he aluminum chassis of this lighting control is designed as a heat sink to dissipate heat generated by the proper functioning of the circuit components. he fins may be very warm to the touch when the lighting control is operating at its maximum rated load. his is normal operation and does not indicate malfunction. 3.) Due to electro-magnetic radiation produced by all solid state lighting controls, the load, dimmer, and connecting wires should be located as far away as possible from radios, intercom units or public address systems. Six feet is the recommended minimum distance. 4.) urn-in lamps at fullbright for a minimum 100 hours before attempting to dim and adjust trim. 5.) Dimmers may be ganged in any combination. See reverse for derating and wallbox size. iring Diagrams: See reverse side. ompatible allasts 120V G-Valmont 8G-5001 dvance Dim 240--P (2 lamp) G-Valmont 8G-5007 (2 lamp) Universal 550- dvance Dim 140- Universal P dvance Dim 140--P Universal 502- (2 lamp) dvance Dim 240- (2 lamp) Universal P (2 lamp) (dditional ballasts may also be compatible with this dimmer. all UN to verify compatibility.) unt ontrol Systems, nc. Fort ollins, O

3 Standard nstallation Single Pole iring Diagram iring Diagrams and Ganging nformation for UN Simplicity rchitecural lectromagnetic Fluorescent ontrols Single Pole and hree ay 120V, 60z ORNG o other control leads O YO o other black leads o other white leads NUR RON U/ U SNG MP S hree ay iring Diagram 40 MP SNDRD 3-Y S ORNG o other control leads O YO o other black leads o other white leads GNGNG: hen ganging two dimmers, break off the inside fins; when ganging three or more, break off the inside fins of the outer units, and both sides of the inner unit(s). reak off as shown. Derating of 10% per side is necessary when fins are removed. SSS R OFF PONS NUR allbox Requirements For Ganging Number of double gang units Number of single gang units _ Minimum size wall box required (in gangs) U/ U SNG MP S 40 MP RON O ND RGNSS DJUSMN O ND RGNSS S FORY DJUSD. F NO SSFORY, MY RMMD S FOOS: Rotate dimmer control knob to full counterclockwise (with unit turned on). djust trim to desired brightness with a small screwdriver. RMPO FP unt ontrol Systems, nc. Fort ollins, O

4 nstallation and iring nstructions for UN Simplicity rchitectural lectromagnetic Fluorescent ontrols Single Pole and hree ay 277V, 60z hese dimmers are designed for electro-magnetic fluorescent, permanently installed fixtures using an approved ballast (see below) and rapid start 40 watt lamps. Models: -ine Series: F-527, F-527-3, F-1027, F , F-1527 ccent Series: SF-527, SF-527-3, SF-1027, SF , SF-1527 Omega Series: SF-527, SF-1027, SF-1527 oad: ( minimum load of two (2) lamps is required) F-527, F-527-3, SF-527, SF-527-3, SF-527: F-1027, F , SF-1027, SF , SF-1027: F-1527, SF-1527, SF-1527: 12 lamps 20 lamps 30 lamps aution: o reduce the risk of overheating and possible damage to other equipment, do not install to control a receptacle, a motor-operated appliance, or a transformer-supplied appliance. vertissement: Pour réduire le risque de surchauffes et les dommages possibles à l'autre équipement, ne pas installer pour contrôler une prise, un appareil moteur-fonctionné, ou un transformateur d'alimentation magnétique appareil fourni. Read arefully efore nstalling Dimmers: o avoid fire, personal injury, and/or damage to dimmer, turn power OFF at circuit breaker and test that power is OFF before wiring. Notes: 1.) Fins must be mounted in vertical position and must not be recessed into the wall. hen stacking dimmers or mounting one above the other, allow a minimum of three inches of clear wall space between the upper and lower finned plates. 2.) he aluminum chassis of this lighting control is designed as a heat sink to dissipate heat generated by the proper functioning of the circuit components. he fins may be very warm to the touch when the lighting control is operating at its maximum rated load. his is normal operation and does not indicate malfunction. 3.) Due to electro-magnetic radiation produced by all solid state lighting controls, the load, dimmer, and connecting wires should be located as far away as possible from radios, intercom units or public address systems. Six feet is the recommended minimum distance. 4.) urn-in lamps at fullbright for a minimum 100 hours before attempting to dim and adjust trim. 5.) Dimmers may be ganged in any combination. See reverse for derating and wallbox size. iring Diagrams: See reverse side. ompatible allasts: 277V Universal P Universal P (2 lamp) unt ontrol Systems, nc. Fort ollins, O

5 Standard nstallation Single Pole iring Diagram iring Diagrams and Ganging nformation for UN Simplicity rchitecural lectromagnetic Fluorescent ontrols Single Pole and hree ay 277V, 60z ORNG o other control leads O YO o other black leads o other white leads NUR hree ay iring Diagram U/ U SNG MP S 40 MP RON O SNDRD 3-Y S SSS R OFF PONS NUR GNGNG: hen ganging two dimmers, break off the inside fins; when ganging three or more, break off the inside fins of the outer units, and both sides of the inner unit(s). reak off as shown. Derating of 10% per side is necessary when fins are removed. ORNG YO allbox Requirements For Ganging Number of double gang units Number of single gang units _ Minimum size wall box required (in gangs) o other control leads o other black leads U/ o other white leads U SNG MP S 40 MP RON O ND RGNSS DJUSMN O ND RGNSS S FORY DJUSD. F NO SSFORY, MY RMMD S FOOS: Rotate dimmer control knob to full counterclockwise (with unit turned on). djust trim to desired brightness with a small screwdriver. FP RMPO unt ontrol Systems, nc. Fort ollins, O