BUSH HOG 2501 Griffin Ave. Selma, AL Contact Us

Transcription

1 RD5/RD6 ROTARY MOWER Published 01/11 PART'S MANUAL SECTION 88 An Operator's Manual was shipped with the equipment. The Operator's Manual is an integral part of the safe operation of this machine and must be maintained with the unit at all times. READ,UNDERSTAND, and FOLLOW the Safety and Operation Instructions contained in this manual before operating the equipment. If the Operator's Manual isnot with the equipment, contact your dealer or Bush Hog to obtain a Free copy before operating the equipment. BUSH HOG 2501 Griffin Ave. Selma, AL Parts Ordering Alamo Group Inc.

2 PARTS ORDERING GUIDE The following instructions are offered to help eliminate needless delay and error in processing purchase orders for the equipment in this section. 1. The Parts Section is prepared in logical sequence and grouping of parts that belong to the basic machine featured in this manual. Part Numbers and Descriptions are given to help locate the parts and quantities required. 2. The Purchase Order must include the name and address of the person or organization ordering the parts, who should be charged, and if possible, the serial number of the machine for which the parts are ordered. 3. The Purchase Order must clearly list the quantity of each part, the complete and correct part number (be sure to include all periods), and the basic name of the part. 4. The Manufacturer reserves the right to substitute parts where applicable. 5. Some parts are unlisted items which are special production items not normally stocked and are subject to special handling. Request a quotation for such parts before sending a Purchase Order. 6. The Manufacturer reserves the right to change prices without prior notice. For maximum safety and to guarantee optimum product reliability, always use genuine BUSH HOG Parts. The use of inferior replacement parts may causepremature or catastrophic failure which could result in serious injury or death.direct any questions regarding parts to: BUSH HOG 2501 Griffin Ave. Selma, AL Contact Us Alamo Group Inc.

3 PART NAME INDEX A FRAME STANDARD ASSEMBLY A FRAME STANDARD ATTACHMENT BLADE BAR ASSEMBLY DRIVELINE ASSEMBLY (MFD. BY COMER) DRIVELINE ASSEMBLY ( MFD. BY BONDIOLI & PAVESI) GEARBOX ASSEMBLY GEARBOX ATTACHMENT (SHIELDING) FRONT AND REAR DEFLECTORS TAILWHEEL ASSEMBLY WHEEL ASSEMBLY CASTER FORK DECALS, SAFETY AND LOGO Alamo Group Inc.

4

5 A FRAME STANDARD ASSEMBLY FLAT REAR BRACE BAR, A-FRAME HEXB 3/4-10 UNC 5-1/2 PL BUSHING 1-1/4X7/32X3 A-FRAME LOCKNUT 3/4-NC TLM PLC TOPLINK 2011 Alamo Group Inc

6 A FRAME STANDARD ATTACHMENT ASY,CAT.1 HITCH PIN W/LW & NUT LOCKWASHER HEX NUT CLIP, LYNCH PIN 13/32 DIA B12 1 CLEVIS PIN, TOP LINK - CAT. I B13 1 PIN, HAIR CLIP HHCS, 1/2-13NC X 1-1/4 PL TOPLOCKNUT, 1/2-13 NC PL DECK WELDMENT for RD DECK WELDMENT for RD Alamo Group Inc

7 RD5 RD 6 BLADE BAR ASSEMBLY WLDMT, BLADE BAR (RD5) WLDMT, BLADE BAR (RD6) BLADE, FAN CCW, 22-1/2 CTR-TIP (RD5) BLADE, FAN CCW, 25-1/2 CTR-TIP (RD6) BLADE BOLT 7/8 DIA X 3 LG WASHER, 7/8 STR PLAIN NUT, TOPLOCK 7/8 NF PLC BLADE BOLT KIT (FOR 2 BLADES) 2011 Alamo Group Inc

8 DRIVELINE ASSEMBLY (MFD. BY COMER) Comer Brand Name on Shielding. NOTE: If part numbers or are present on the outer shielding you must order parts from the B&P Driveline. The Comer Driveline Implment Yoke has a recessed holes that the Shear Bolt Head and locknut fit down inside. THIS DRIVELINE MANUFACTURED BY COMER. BEFORE ORDERING REPAIR PARTSFIRST DETERMINE IF THE DRIVELINE IS A COMER OR A BONDIOLI & PAVESI MANUFACTURED DRIVELINE. THIS DRIVELINE REPLACED BY DRIVLENE ASSY. MANUFACTURED BY BONDIOLI & PAVESI B 1 DRIVELINE, SP A 1 ASSY,YOKE COLLAR - COMPLETE CROSS & BEARING KIT SERIES A 1 YOKE, 1-3/8 BORE SP 4 N/A 1 YOKE & OUTER TUBE 5 N/A 1 YOKE & INNER TUBE PIN ROLL 8MM X 60MM PIN ROLL INNER TUBE COMPLETE SHIELD KIT SLIDE COLLAR REPAIR KIT RETAINER, INNER COLLAR RETAINER, OUTER COLLAR SHIELD BOLT, NYLON 2011 Alamo Group Inc

9 DRIVELINE ASSEMBLY (MFD. BY BONDIOLI & PAVESI) 2 The B&P Driveline Implement Yoke is round B&P Brand Name on Shielding. 6 NOTE: If part numbers or are present on the outer shielding you must order parts from the B&P Driveline. THIS DRIVELINE MANUFACTURED BY BONDIOLI & PAVESI. BEFORE ORDERING REPAIR PARTS FIRST DETERMINE IF THE DRIVELINE IS A BONDIOLI & PAVESI OR A COMER MANUFACTURED DRIVELINE. THIS DRIVELINE REPLACES THE B DRIVLENE ASSY. MANUFACTURED BY COMER DRIVELINE ASSEMBLY, B&P ASSY,YOKE COLLAR - COMPLETE CROSS & BEARING KIT ROLL PIN 8MM X 60MM OUTER TUBE ROLL PIN 8MM X 55MM inner TUBE YOKE 1/3/8 BORE W/ GREASE FITTING SHIELD SUPPORT, OUTER SHIELD SUPPORT, INNER BALL COLLAR KIT GREASE FITTING SHIELD KIT, COMPLETE 2011 Alamo Group Inc

10 RD5 RD 6 GEARBOX ASSEMBLY GEARBOX ASSY,- 40HP 540 RPM, 1:1.47 RATIO COVER,INPUT GEARBOX COVER,OUTPUT GEARBOX SHAFT,INPUT - SMOOTH KIT,ROLLER BEARING KIT,BEVEL GEAR KIT,SHIM NUT,FLANGE HEX SLOTTED PLUG,VENT 1/ PLUG,SOLID 1/ SNAP RING, DRIVE SHAFT RETAINER SEAL, OIL 40 X 54 X SEAL, OIL 34.9 X 54 X Alamo Group Inc

11 GEARBOX ATTACHMENT SAFETY SHIELD GEARBOX SHIELD INNER SUPPORT RING FLATWASHER, 5/16 TYPE,AW,ZP /16 X 3/4 HHCS BOLT, 5/8 X 2 PL /8 HARDENED WASHER NUT,5/8 NC TOPLOCK 8 7A SHEAR BOLT LOCKNUT SNAP RING, DRIVESHAFT RETAINER 2011 Alamo Group Inc

12 GUARD ASSEMBLY DEFLECTOR, FRONT RD DEFLECTOR, FRONT RD HHCS, 1/2-13NC X 1-1/4 PL TOPLOCKNUT, 1/2-13 NC PL FLATWASHER 1/ BAND REAR RD BAND REAR RD Alamo Group Inc

13 TAILWHEEL ASSEMBLY WLDMT, TAILWHEEL BEAM SEE (CASTER FORK & WHEEL ASSY) CAPSCREW 1/2 NC X 3-1/4 PL NUT, 1/2-13 NC PL,TOPLOCK NUT,5/8 NC, TOPLOCK CAPSCREW 5/8 NC 3-1/4 PL RIVET, 3/16 POP X 15/32" G.R CANISTER, OPERATORS MANUAL 2011 Alamo Group Inc

14 WHEEL ASSEMBLY & CASTER FORK FORK CASTER ASSEMBLY 2 15B WASHER SAE 1 1/4 PLATED PIN-COTTER 1/4 X 2-1/ BOLT SPINDLE M24 x 2 x NUT, SPINDLE M24 X BUSHING, SINTERED IRON GREASE FITTING M8 X WHEEL ASSEMBLY 16 X Alamo Group Inc

15 DECALS - SAFETY AND LOGO SHEET, SAFETY DECAL (Items 2, 4, 5, 11, 19) RD5 SHEET DECAL, LOGOS (Items 1, 3, 6, 7, 8) RD6 SHEET DECAL, LOGOS (Items 1, 3, 6, 7, 8) 1 D395 1 IMPORTANT, Replace Blades in Pairs DANGER, Shear Bolt Length 3 D590 1 LUBE, Lubrication Points 4 D388 1 DANGER, Driveline Hazard 5 D389 1 DANGER, General Multi-Hazard 6 D559 1 WARN / IMPORTANT, Use Genuine Parts LOGO Bush Hog Logo Decal (Order Logo Decal Sheet) RD5 Model Decal RD6 Model Decal REFLECTOR, Red Reflectors 10 n/a 1 SERIAL PLATE Serial Number Plate DANGER, Shield Missing (Not Shown) REFLECTOR, SMV Triangle Canister, Operators Manual C 1 Operator s Manual Bolt Flatwasher Locknut 18 D137 1 ROTATION, Blade Rotation Decal 19 D554 2 DANGER, Thrown Objet Shield Missing 2011 Alamo Group Inc

16

17

18 2501 GRIFFIN AVE. SELMA, AL (334) (334) PARTS ORDERING FAX