Yes Minimum octane rating RON 95. Cam/ Crankshaft Fuel System. Trigger location. Air metering Combined ignition and fuel ECM. Yes Diagnostic socket

Size: px

Start display at page:

Download "Yes Minimum octane rating RON 95. Cam/ Crankshaft Fuel System. Trigger location. Air metering Combined ignition and fuel ECM. Yes Diagnostic socket"

Reginald Martin
5 years ago
Views:

1 Vehicle identification No. of cylinders Type 4/DOHC Capacity (Fiscal) cc 1998 Compression ratio :1 11,0 Suitable for unleaded petrol Minimum octane rating RON 95 Ignition system Description Map-DI Trigger location Cam/ Crankshaft Fuel system Make Toyota Fuel System Type EFI Fuel System Description MFI-s Air metering Type Mass Combined ignition and fuel ECM Diagnostic socket Ignition system Firing order Tuning and emissions 49 Tuning conditions Ignition timing - basic BTDC Engine/rpm 8-12/675 Not adjustable Ignition advance checks Engine/rpm ECM Controlled Idle speed rpm 675±50 Not adjustable Oil temperature for CO test C 80 CO level at idle speed - tailpipe Vol. % CO 0,5 Max Not adjustable HC level at idle speed ppm 100 CO2 level at idle speed Vol. % CO2 14,5-16 O2 level at idle speed Vol. % O2 0,1-0,5 Increased idle speed for CO test rpm

2 CO content at increased idle speed Vol. % 0,3 Lambda at increased idle λ 0,98-1,02 Original equipment Denso Spark plug Type SK20BR11 Electrode gap mm 1,0-1,1 Make NGK Spark plug Type IFR6A-11T Electrode gap mm 1,0-1,1 Fuel system Regulated pressure with vacuum bar 3,8-4,2 Engine coolant temperature (ECT) sensor Ohm/ C /80 RPM/TDC sensor Ohm Injector Ohm 2,55-2,85 Injector opening duration (hot) ms/rpm 0,4-0,8 Oxygen sensor heater Ohm Service checks and adjustments Valve clearance -INLET mm 0,19-0,29 cold Valve clearance -EXHAUST mm 0,30-0,40 cold Compression pressure bar 10-14,7 Oil pressure bar/rpm 2,5-5,4/3000 Radiator cap bar 0,74-1,03 Thermostat opens C Lubricants and capacities Engine oil grade - cold climate SAE 5W/30 Engine oil grade - moderate climate SAE 10W/30 Engine oil classification API/ACEA SJ/A1-98 Engine oil grade - alternative - moderate climate SAE 15W/40 Engine oil classification - alternative - moderate climate API/ACEA SJ/A1-98 Engine with filter litres 4,3 Gearbox oil grade SAE 75W/90 Semi-Synth. Gearbox 4/5 speed litres 2,2 Automatic transmission fluid Type ATF T-IV Automatic transmission (drain & refill) litres 4,1 Cooling system litres 7,7 AT=8,2 Brake fluid Type DOT 3 Power steering fluid Type Dexron III Power steering fluid litres 0,8 Tightening torques Cylinder head instructions Cylinder head Maximum bolt length 164,2 Stage 1 Tighten 40 Nm Stage 2 Tighten 7 Stage 3 Tighten 90

3 Other tightening torques 123 Main bearings Renew bolts/nuts 100 Big end bearings Renew bolts/nuts Big end bearings Stage 1 25 Nm Big end bearings Stage 2 90 Oil pump to cylinder block Sump bolts Sump drain bolt 25 Nm Flywheel/driveplate 130 Nm/83 Nm Clutch to flywheel Crankshaft pulley/damper 170 Nm Camshaft sprocket/gear 54 Nm 98 Camshaft carrier/cap 122 Camshaft/rocker cover Inlet manifold to cylinder head 30 Nm Exhaust manifold to cylinder head 37 Nm Exhaust downpipe to manifold 62 Nm Fuel rail to inlet manifold Crankshaft position (CKP) sensor Camshaft position (CMP) sensor Engine coolant temperature (ECT) sensor 20 Nm Oxygen sensor (Lambda) 44 Nm Knock sensor (KS) 44 Nm Engine oil pressure switch 13 Nm Front hub 216 Nm Steering track rod end 4 Brake caliper carrier to hub Front 94 Nm Brake caliper to carrier Rear 30 Nm Brake caliper carrier to hub Rear 47 Nm ABS sensor Front 8 Nm ABS sensor Rear 8 Nm Road wheels 103 Nm Starting and charging Battery V/RC(Ah) 12 (48) Maximum cranking amps A Alternator output at engine speed A/V/rpm 80/-/- Brake disc and drum dimensions Minimum disc thickness - ventilated Front 26 mm Minimum disc thickness Rear 9,0 mm Disc runout Front 0,05 mm Disc runout Rear 0,15 mm Minimum pad thickness Front 1 mm Minimum pad thickness Rear 1 mm Handbrake travel No. of notches 4-7 Air conditioning Air conditioning refrigerant Type R134a

4 Note 49 Air conditioning refrigerant quantity grams Air conditioning oil Type ND-Oil 8 Ignition timing, idle speed Bridge terminals 4 & 13 of data link connector in facia panel fuse block. Fig Note 123 Main bearings Min bolt diameter = 7,2 mm Tighten in the following stages: 1) 20 Nm 2) 40 Nm 3) 90. Note 100 Big end bearings Minimum bolt diameter = 7,0 mm. Fig Autodata Note 98 Camshaft carrier/cap Front caps = 30 Nm Others =. Autodata Note 122 Camshaft/rocker cover Centre bolts (x2) = 14 Nm Outer nuts/bolts (x7) = 11 Nm Outer bolts (x2) = 21 Nm.

5 Timing mark Tightening sequence

VOLKS CITY BEECH AVENUE CATTEDOWN PLYMOUTH PL4 0QQ

VOLKS CITY BEECH AVENUE CATTEDOWN PLYMOUTH PL4 0QQ Telephone: 01752 667007 Fax: 01752 663399 Email: mail@volkscity.com Notes Specified value Measured value Vehicle identification No. of cylinders Type