SERVICE PARTS MANUAL The ICE Series Undercounter Cubers MODEL-ICEU150A4,A5,A6-W4,W5,W6 ICEU220A2,A3-W2,W3 ICEU225A2,A3-W2,W3 ICEU226A2,A3-W2,W3

Transcription

1 SERVICE PARTS MANUAL The ICE Series Undercounter Cubers MODEL-ICEU150A4,A5,A6-W4,W5,W6 ICEU220A2,A3-W2,W3 ICEU225A2,A3-W2,W3 ICEU226A2,A3-W2,W Date 12/14/ E. 45th Avenue Denver, CO

2 *

3 Table of Contents This parts list contains the service parts available for the following ICE Undercounter icemakers: ICEU150A4,A5,A6-W4,W5,W6 ICEU220A2,A3-W2,W3 ICEU225A2,A3-W2,W3 ICEU226A2,A3-W2,W3 Check the model number on the data plate and refer to the correct listing for the specific component. Check carefully that the correct part is identified and ordered. Table of Contents Page 1 Bin and Exterior Components Page 2-3 Refrigeration System Page 4-5 Harvest Assist Assembly Page 6 Control Box Page 7 Evaporator Page 8 Water Pump Page 9 Ice-O-Matic East 45th Ave. Denver Co The ICE Series Service Manual is available seperately, Part Number Page 1

4 Bin and Exterior Components Page 2

5 Bin and Exterior Components Trim Strip RH Trim Strip LH Panel, Rear Access Strain Relief Power Cord (115 Volt units only) Front Grill (2 required, sold each) Front Grill Screw Bin Assembly (Includes Item 10) Screw Hex Head Drain Elbow Clamp Bin Door Assembly Bin Door Thumb Screw Door Stop Bin Top Assembly Plastic Corner Cap Left Side Plastic Corner Cap Right Side Truss Head Sheet Metal Screw-Plastic Corner Top Panel Screw Right Side Panel Left Side Panel Control Box Cover Leg Set (4 each) Ice Scoop Rear Panel Drain Fitting 22 N/A N/A N/A Cover Base Panel Thumb Nut Three Prong Page 3

6 Refrigeration * Compressor (*Part Number Changed) ** Expansion Valve-Danfoss(**Part Number Changed) Drier (Replaces ) Service Valve Body Service Valve Core Service Valve Cap Hot Gas Valve Body Hot Gas Valve Coil Purge Valve (Replaces Purge Valve) The ICEU150 Compressors (ASB14C3E-IAA) is NLA and (ASE14C4E-IAA)is NLA. Replaced by (ASE24C3E-IAA) See Page 5 for Compressor Components (Reference Compressor for Starting Components) The Expansion Valve has been changed to a more efficient model. Part Number is NLA, Replaced by Page 4

7 Refrigeration Flat Washer Grommet Lock Nut Sleeve Compressor Mounting Lock Nut (Leg) Base Assembly Water Condenser Condenser Water Out Fitting Water Trough Assembly Water Trough From SN A Water Trough Screws 15B Rubber Washer Water Trough Screws Fan Bracket Fan Motor Fan Motor (From Serial Number ) Fan Blade Fan Shroud Air Condenser Purge Drain Tube Hose Clamp Barbed Tee Tubing 9/16 x 20 Inches Long Hose Clamp Drain Adapter Rear Panel Water Regulator Drop Adapter Fitting Water Iinlet Fitting Flanged Lock Nut High Temperature Safety Control High Temp Safety Control-From SN Drop Adapter Fitting-From SN Water Inlet Body* -From SN Water Inlet Nut** -From SN High Pressure Control-From SN Bin Stat Bracket Assy, From SN Tube, Bin Control, From SN *Note is the Water Inlet Body Only, it DOES NOT include Nut **Note is the Nut Only, it DOES NOT include the Water Inlet Body ICEU150 ICEU220 ICEU225 ICEU226 Description Compressor Overload Start Capacitor Compressor Relay Compressor (ASE14C4E-IAA) NLA Overload Start Capacitor Compressor Relay Compressor (ASB14CE-IAA) NLA Overload Start Capacitor Compressor Relay *Note: When installing a Compressor, it is recommended that the Fan Motor be installed. Page 5

8 Harvest Assist Assembly Reference the Model Number below for the specific Harvest Assist Assembly A* A* A7* A* Harvest Assist Assembly - 60 Degree Clutch S* S* S* S* No Longer Available A** A1** A** A** Harvest Assist Assembly - See Note Below S** S** S** S** No Longer Available *Note, Prior to November of 2012 (SN1211) **Note, From November 2012 (SN1211) The XXA assembly will fit all ICE Models from October 1999 and EC Models. Units installed with a double cam switch, either Field installed or Factory installed will require the complete assembly and a potential wiring change as per the New Wiring Diagram included with the assembly. Individual component parts are not available for the XXA assembly. Individual component parts are No Longer Available for previous version of the Harvest Assist Assembly Parts for the XX Harvest Assist Assembly are not compatible with XXA Harvest Assist Assembly. Proper assembly and alignment of the parts is critical to proper operation, this includes cam and probe alignment. If a XXA assembly fails, it must be returned to Ice-O-Matic XXA are only supplied as complete assemblies, individual components are not available. Please reference the above Model Numbers to insure the correct assembly is supplied THE DUAL CAM SWITCH HARVEST ASSIST ASSEMBLIES ARE NO LONGER AVAILABLE No Longer Available No Longer Available S No Longer Available No Longer Available S No Longer Available No Longer Available S No Longer Available No Longer Available Page 6

9 Control Box Water Pump Connector Terminal Block Switch-Purge (Prior to SN is NLA) Switch-Purge (From SN is NLA) Ice/Off/Wash Switch ( is NLA) Thermostat-Bin Control A A A A Low Pressure Control* (Replaces ) High Pressure Control High Pressure Control-From SN Timing Module Relay Socket-Relay Hold Down Spring - Relay High Temperature Safety Control High Temp Safety Control-From SN Contactor-From SN *Note Includes Sovlent and Adhesive Page 7

10 Evaporator S S S S Evaporator-Half Cube (Shown) S S S S Evaporator-Full Cube Water Distribution Tube Thumbscrew Rubber Washer Spillway Left Side Evaporator Mounting Panel Right Side Evaporator Mounting Panel Water Return Page 8

11 Water Pump See Page 4 for Water Inlet Fittings Water Pump Pump Bracket Plastic Nut Float ( Includes Fittings)* Cap Plug Plastic Barbed Tee 5/ Plastic Clamp Hose PVC 9/16 (Formed) Hose PVC 5/ Inch Required Tube-Polyethylene - 8 Inches Required Barrel Fitting Sleeve Plastic Clamp *Note: The is NLA, Replaced by which includes fittings. Page 9