Reproduction. Not for TWO STAGE LARGE FRAME SNOW THROWER 27" 11.5TP. Parts Manual for M1277E Snowthrower, 27"

Transcription

1 Parts Manual for TWO STAGE LARGE FRAME SNOW THROWER 27" 11.5TP Model No. Description M1277E Snowthrower, 27" Briggs & Stratton Yard Power Products Group 535 Macon Road McDonough, GA, U.S.A Manual No Revision: A 7/21/2009

2

3 Table Of Contents PAGE GROUP 4 Handle & Controls Group 8 Auger Housing Group 10 Discharge Chute Group 12 Auger Drive Group 14 Gear Case Assembly 16 Engine & Frame Group 18 Traction Drive Group 20 Wheel Group 22 Decals Group TWO STAGE LARGE FRAME 3 Manual No TP LF-N

4 Manual No TWO STAGE LARGE FRAME 4

5 Handle & Controls Group Item Part No Qty Description CAPSCREW, Hex Head, 3/8-16 x 2 G LEVER, Deflector Control WASHER, 3/ SPRING WASHER, 3/ NUT, Hex Lock, Esna Light, 3/ LEVER, Clutch, Left BUSHING, 3/5ID SPEED LEVER CAPSCREW, Hex Head, 1/4-20 x 1-3/4 G BRACKET, Controls ROD, 25.3/8 Long NUT, Hex Flange, Whiz Lock, 5/ NUT, Hex, 5/ BRACKET, Mounting, Dash, Left BALLJOINT LOCKWASHER, Spring, 5/ HARNESS, Wire, Headlights BUSHING, Chute Crank BOLT, Carriage, 1/4-20 x 2 G NUT, Hex Lock, Esna Light, 1/ SCREW, Hex Washer Head, Taptite, 1/4-20 x 5/ KNOB, Internal Thread, 3/ DASH ASSEMBLY, Twin Light SCREW, Pan Head Torx, 1/4-20 x 3/ CAPSCREW, Hex Head, 1/4-20 x 1-1/2 G BOLT, Carriage, 5/16-18 x 3/ BRACKET, Mounting, Dash, Right ASSEMBLY, Cable & Spring, Right LEVER, Clutch, Right NUT, Hex Centerlock, 1/ GRIP SPACER, Stepped SPACER, 1/4ID x 3/8OD x 5/ BRACKET, Rod Support A 1 HANDLE, Upper, Right A 1 HANDLE, Upper, Left Footnotes: TWO STAGE LARGE FRAME 5 Manual No

6 Handle & Controls Group Manual No TWO STAGE LARGE FRAME 6

7 Handle & Controls Group Item Part No Qty Description BOLT, 5/16-18 X 2 GR A 1 HANDLE, Lower KNOB, Wing, 5/ LOCKWASHER, Internal Tooth, 5/ NUT, Hex Toplock Jam, 5/ HEADLIGHT ASSEMBLY SCREW, Hex Washer Head, Taptite, 5/16-18 x 3/ BRACKET, Cable Adjusting BOOT, Spring End Cover CABLE, FR-DR P7 EXT-HDL A 1 BRACKET, Pivot, Free Hand SPACER, 1/4ID x 3/8OD x 1/ ROD & SPRING ASSEMBLY SPRING, Compression, 2-1/2 Inch WASHER, 1/ ROD, 5-1/2 Long TIE, Self Locking KNOB, Slot Speed WASHER, 1/ SCREW, Hex Washer Head, Hi-Lo, #10-16 x 1/ SCREW, Round Head Phillips, #10-24 x 3/ NUT, Hex Lock, SCREW, Hex Washer Head, Self Tap, 1/4-15 x 3/ NUT, Hex Flange, Two-Way Lock, 5/ CAPSCREW, Hex Head, 5/16-18 x 1 G PLUG WASHER, Flat A 1 SUPPORT, Dash Panel Footnotes: TWO STAGE LARGE FRAME 7 Manual No

8 Auger Housing Group Manual No TWO STAGE LARGE FRAME 8

9 Auger Housing Group Item Part No Qty Description D 1 HOUSING CLIP, Retainer SCREW, Truss Head Torx, #10-24 x 3/ NUT, Nylock, 10 x BRUSH, Cleanout BEARING, Auger Shaft SCREW, Hex Washer Head, 5/16-18 x 3/ BOLT, Carriage, 3/8-16 x 3/4 GR NUT, Hex Flange, 3/ NUT, Hex Flange, Serrated Lock, 5/ A 2 SKID, Shoe Reversible A 1 BLADE, Scraper RETAINER, Ball Bearing BEARING, Ball BOLT, Hex, 5/16-18 x 5/ PLUG BOLT, Carriage, 5/16-18 x 5/8 GR A 2 DRIFT CUTTER BOLT, Carriage, 5/16-18 x 3/ NUT, Wing, 5/16-18 Footnotes: TWO STAGE LARGE FRAME 9 Manual No

10 Discharge Chute Group Manual No TWO STAGE LARGE FRAME 10

11 Discharge Chute Group Item Part No Qty Description PINION NUT, Hex Flange, Whiz Lock, # SCREW, Hex Washer Head,#10C x 1-1/4 G SCREW, Hex Washer Head, Taptite, 1/4-20 x 3/ COVER, Electric Chute Rotation RETAINER, Spout SCREW, Hex Washer Head, Plastite, x 5/ SPRING, Compression, 6 Inch SWITCH, Chute Rotation CABLE, Delfector Control NUT, Push, 5/ A 1 ROD, Spring Guide, 5-7/ DECAL, Chute Hinge D 1 CHUTE NUT, Hex Flange, Esna, 5/ BOLT, Carriage, 5/16-18 x 3/4 G MOTOR, Spout Rotator A 1 GEAR, Short, Steel Chute ADAPTER, Chute Ring BOLT, Carriage, 1/4-20 x 3/4 G NUT, Hex Flange, Esna, 1/ WASHER, Nylon, 3/8 Footnotes: TWO STAGE LARGE FRAME 11 Manual No

12 Auger Drive Group 0600 Manual No TWO STAGE LARGE FRAME

13 Auger Drive Group Item Part No Qty Description A 1 AUGER, Left A 1 AUGER, Right SCREW, Hex Head, 1/4-20 x 1-3/4 GR SPACER, Sleeve NUT, Hex, Centerlock, 1/ SPACER, Friction Pulley KEY, Square PULLEY, 4L 8.40 OD NUT, Hex Flange, Serrated Lock, 1/ GEAR CASE ASSEMBLY Footnotes: TWO STAGE LARGE FRAME 13 Manual No

14 Gear Case Assembly Manual No TWO STAGE LARGE FRAME 14

15 Gear Case Assembly Item Part No Qty Description WASHER, Thrust BEARING, Roll BREARING, Flange CASE, Gear, Left CASE, Gear, Right SHAFT, Auger Out KEY, Woodruf GEAR, Worm WORMGEAR GASKET, Gear Box RING, Quad KEY, HI-PRO BEARING, Sleeve, 3/4ID x 7/8OD BEARING, Sleeve SEAL, Oil CR PLUG, Pipe WASHER, NUT, Hex Flange, Serrated Lock, 5/ BOLT, Hex, 5/16-24 x SCREW, 5/16-24 x 1-1/ A 1 IMPELLER Footnotes: TWO STAGE LARGE FRAME 15 Manual No

16 Engine & Frame Group Manual No TWO STAGE LARGE FRAME 16

17 Engine & Frame Group Item Part No Qty Description C E8 1 * ENGINE, 11.5TP, B&S (Engine Model: 15C E8) CORD, Starter BOLT, Carriage, 5/16-18 x 1-1/ NUT, Push NUT, Hex Flange, Whiz Lock, 5/ PULLEY, Engine WASHER, 5/ CAPSCREW, Hex Head, 5/16-24 x 1-1/4 G V-BELT, Drive, 3L, BELT, Auger, V4L BELT GUIDE LOCKWASHER, Spring, 5/ CAPSCREW, Hex Head, 5/16-24 x 3/4 G BRACKET, Idler BUSHING, Idler Bracket SPRING, Extension Idler IDLER NUT, Hex Centerlock Jaam, 3/ BOLT, Carriage, 3/8-16X x 1-1/4 G AUGER IDLER SPACER, 1/2ID x 1OD x 1-3/ WASHER, 1/ ARM, Control PIN, Hair PIN, Clevis A 1 PANEL, Bottom SCREW, Hex Washer Head, Taptite, 1/4-20 x 5/ SPRING, Extension Auger D 1 FRAME BOX D 1 PLATE, Engine Mount SCREW, Hex Washer Head, Taptite, 5/16-18 x 1/ SCREW, Hex Washer Head, Taptite, 5/16-18 x 3/ COVER Screw, Self Tapping, 1/4 x 3/ BOLT, Hex, 5/16-24 x COTTER PIN, 1/ CAP, Fuel Tank, With Gasket Footnotes: Note* See your local Briggs & Strattion Distributor for Parts & Service. TWO STAGE LARGE FRAME 17 Manual No

18 Traction Drive Group Manual No TWO STAGE LARGE FRAME 18

19 Traction Drive Group Item Part No Qty Description CHAIN, Roller, 19 Inch RETAINER & BUSHING ASSEMBLY WASHER, Flat, 1/ SCREW, Hex Washer Head, Taptite, 5/16-18 x 1/ CHAIN, Roller, 18 Inch RETAINER, Ring, 7/ SPRING LINK SPRING, Extension SPROCKET WASHER, 1/ AXLE, Swing Plate AXLE BOLT, Hex, 1/4-20 x 1-3/4, G AXLE SPROCKET, 30T BEARING, Axle, D-Hole ASSEMBLY, Hex Shaft & Sprocket HUB, Friction Wheel and Bearing WHEEL, Friction CAPSCREW, Hex Head, 1/4-20 x 5/8 G NUT, Hex Keps, 1/ RING, Retaining NUT, Flange Lock, 3/ PLATE, Swinging SPACER, Friction Pulley ASSEMBLY, Friction Pulley SPEED SELECTOR BEARING, Flange, 1/2ID x 7/8OD NUT, Hex Lock, Esna Light, 1/ CAPSCREW, Hex Head, 1/4-20 x 1-1/2 G SPOOL CABLE, Auger Control BRACKET, Cable Spool CABLE, Front Lower Drive Footnotes: TWO STAGE LARGE FRAME 19 Manual No

20 Wheel Group Manual No TWO STAGE LARGE FRAME 20

21 Wheel Group Item Part No Qty Description WHEEL ASSEMBLY, 8X4.8 P2-539, Left VALVE STEM AND CAP WHEEL ASSEMBLY, 8X4.8 P2-539, Right RETAINING RING WASHER, Flat, 3/ BUSHING,Wheel BOLT, HEX, 1/4-20 x 3/4, G NUT, Hex, Nylock, 1/ PIN, Klik Footnotes: TWO STAGE LARGE FRAME 21 Manual No

22 Decals Group Manual No TWO STAGE LARGE FRAME 22

23 Decals Group Item Part No Qty Description DECAL, Danger Chute, FR/ENG DECAL, Danger Foot, FR/ENG DECAL, Auger Control Symbols DECAL, Traction Control DECAL, Controls, With Remote DECAL, Speed Control DECAL, Logo DECAL, Auger Housing MANUAL, Operators MANUAL, Illustrated Parts List Footnotes: TWO STAGE LARGE FRAME 23 Manual No

24

25

26

27

28 Parts Manual for TWO STAGE LARGE FRAME SNOW THROWER 27" 11.5TP IT IS THE POLICY OF BRIGGS & STRATTON CORP TO IMPROVE ITS PRODUCTS WHENEVER IT IS POSSIBLE AND PRACTICAL TO DO SO. WE RESERVE THE RIGHT TO MAKE CHANGES OR ADD IMPROVEMENTS AT ANY TIME WITHOUT INCURRING ANY OBLIGATION TO MAKE SUCH CHANGES ON PRODUCTS Briggs & Stratton Yard Power Products Group 535 Macon Road McDonough, GA, U.S.A Copyright 2009 Briggs & Stratton Corporation Milwaukee, WI USA. All Rights Reserved Manual No Revision: - 7/17/2009